GSE Negative Pressure, Temperature and Humidity Controller 16A

With this GSE controller you can connect large extractors (up to 16A). It has a negative pressure sensor, keeping your extractor and intractor perfectly balanced so that no unwanted smells can get out of your grow room.

In other words, it will always extract more air than the intractor takes in, avoiding any smells escaping your secret garden – your air will go through an anti-odor filter which should be placed towards the tallest point of the ceiling in order to get rid of pockets of stale air, then through an extractor and a flexible aluminum duct and to the outside.

It’s made out of top quality materials, and its casing is waterproof. The sockets have lids, too, and on the lower half there are some cables with two sensors that measure the climate and detect day and night in your grow room. The cables in the sensors can measure up to 4m, giving you plenty of space to place them correctly.

You also have the ability to connect an intractor and air extractor of around 2.200w, and it also has two outlets that you can plug two devices into such as a dehumidifier, humidifier, heater etc.…

GSE technical details:

• Box: 120x180x80mm
• Controller: 150x210x110mm
• Voltage: 230v/50Hz
• Digital sensor 5v
• Temperature range: -55º to +125ºC
• Precision: 0.5 from -10º to +85ºC

Range:

• Temperature: 20º to -30ºC
• Speed: off, 20 to -100%
• Negative pressure: 100 to 50%

ATTENTION: This product is delivered within 48/72h