Evolution Digital CO2 Controller and Analyser

With the Evolution CO2 Controller by Ecotechnics we can control the CO2 ppm available in the grow space’s atmosphere. It comes with the best measuring devices and the best technology to control your crop’s CO2 levels.

A digital screen will display at any time the CO2 levels of our crop via a high-technology microchip analyser, very accurate from 0 to 10,000 ppm.

You can connect it to any CO2 bottle or butane/propane CO2 generator.

One of the best devices to control the CO2 in our marijuana crop. 

This device also constantly controls the temperature and the humidity and adjusts the extractor fan’s speed to optimise the growing conditions of our plants. The plants grown under these optimised environments develop at greater speeds and larger, what means a production increase and a reduction of the crop’s cycle times.

Once the controller has been installed, it has to be connected to the power and it will display the current temperature and humidity. From that moment on, you can use the controller’s keys to adjust the necessary parameters. Next, we will explain the system’s keys.

Once it’s been adjusted, the controller will turn the fans on at the minimum speed needed to provide the set values of temperature and humidity, what will make the fan work silently, reducing the operating costs while improving the crops conditions.

Specifications:

• Power: 15 W Max.
• Voltage: 230-240 V / AC
• Total load: 3.0 kW

Safety recommendations:

• Make sure the unit is always unplugged before connecting the fan and/or the unit’s heater.
• Always check that all cables and wires have been properly connected and that the cover has been safely screwed back in place before plugging the unit to the electric power.
• Remember that combining water and electricity is always very dangerous. Electricity can be fatal, especially in the presence of water.
• We highly recommend the installation of electrical appliances, in grow spaces, above the floor level, in a shelf or attached to the walls, to avoid their contact with water in case there’s a leak or an accidental spill.
• This device should be installed by a qualified electrician and must be connected via a safety RCD circuit breaker.