Boveda 62% Humidity Regulator for Curing

Generally, when curing your weed you don’t know what the perfect humidity level is, and it can be hard to achieve without a little extra help. Now, even if it’s a bit dry when you begin curing it, with a packet of Boveda you can automatically adjust the humidity levels in your curing containers, keeping them at around 62% RH.

Boveda is a product made in USA, and it comes in concentrations of 93% humidity and 13% humidity, allowing you to keep your cannabis under the absolute perfect conditions as well as allowing you to cure the resin on your flowers.

These packs are full of gel that can either add or remove humidity to keep it at 62%. This gel begins getting harder as time goes by, and once it’s fully hard you’ll need to switch it out for a new pack – depending on how dry your weed is they can last from 15 days to a month.

8g packets can do for 0-2L containers, although if your container is over 2L you’ll need a 60g packet.

How to use:

First you’ll need to dry your cannabis as usual, whether it’s by hanging the entire plant or branch by branch.

Once it’s dry and the stems begin to crunch it’ll be ready to place inside your curing container. Once in the container you’ll simply have to place a Boveda packet inside and close it up.

You’ll need to check it every two days to make sure it’s doing good. After about 15 days your weed will have improved in quality quite a lot.

After 30 days it’ll be ready to smoke – extremely potent and a much stronger flavor.